All Products
Contact Person :
lei
Phone Number :
13266828705
Keywords [ transparent polyethylene granules ] match 20 products.
VIDEO
Ultra-Clear Pp Granules Injection Molding Grade For High Transparent Packaging Boxes
| Density / Specific Gravity: | 0.9 G/cm³ |
|---|---|
| Melt Mass-Flow Rate (MFR) 190°C/2.16 Kg: | 30g/10 Min |
| Packaging Details: | 25.5 tons in 40-foot container |
VIDEO
Toughened Grade Polyethylene Pellets High Flow Plastic Flower Raw Material
| MFR: | 55 G/10 Min |
|---|---|
| Durometer Hardness: | 90A |
| Vicat Softening Temperature: | 90 °C |
VIDEO
Explosion Proof Polyethylene PE Particles For Braided Water Inlet Pipes
| MFR: | 0.3 G/10 Min |
|---|---|
| ESCR: | 30.0 Hr |
| Durometer Hardness: | 90A |
Braskem Green PE STS7006 LDPE Pellets Bio Based Polyethylene Granules 0.925 G/Cm3
| Density (23°C): | 0.925 G/cm³ |
|---|---|
| Melt Mass-Flow Rate (MFR) (190°C/2.16 Kg): | 0.6 G/10 Min |
| Molding Temperature: | 170 -190 °C |
Acid Alkali And Chemical Resistant PE Hose Granules Are Highly Transparent And Elastic
| Density: | 0.908 G/cm³ |
|---|---|
| (MFR) (190°C/2.16 Kg): | 1.0 G/10 Min |
| Packaging Details: | 25 tons in 40-foot container |
Lupolen 2421F Lyondellbasell LDPE
| Tensile Strength At Yield: | 18MPa |
|---|---|
| Processing Temperature: | 160-200°C |
| Melt Index: | 0.75g/10 Min |
Bio Based Polyethylene LDPE Particles Sugarcane Material Braskem Green PE SEB853/72
| Density (23°C): | 0.923 G/cm³ |
|---|---|
| Melt Mass-Flow Rate (MFR) (190°C/2.16 Kg): | 2.7 G/10 Min |
| Molding Temperature: | 170 -190 °C |
Prime Polymer Evolue Sp1520 Blown Film
| Melt Mass-Flow Rate (MFR): | 2 G/10 Min |
|---|---|
| Density: | 0.919 G/cm³ |
| Durometer Hardness (Shore D, Injection Molded): | 54 |
Prime Polymer Evolue Sp0510 Lldpe Blown Film
| Melt Mass-Flow Rate (MFR): | 1.2 G/10 Min |
|---|---|
| Density: | 0.903 G/cm³ |
| Durometer Hardness (Shore D, Injection Molded): | 50 |
Prime Polymer Evolue Sp1510 Lldpe, Blown Film
| Melt Mass-Flow Rate (MFR): | 1.0 G/10 Min |
|---|---|
| Density: | 0.915 G/cm³ |
| Durometer Hardness (Shore D, Injection Molded): | 55 |