All Products
Contact Person :
lei
Phone Number :
13266828705
Keywords [ low density polyethylene pellet blown film ] match 22 products.
Lupolen 2420d Lyondellbasell LDPE
Tensile Strength At Yield: | 17.5 MPa |
---|---|
Processing Temperature: | 160-200°C |
Melt Index: | 2 G/10 Min |
Prime Polymer Evolue PE SP4020 Blown Film
Melt Mass-Flow Rate (MFR): | 1.8 G/10 Min |
---|---|
Density: | 0.937 G/cm³ |
Processing Method: | Blown Film |
Lupolen 2427K LyondellBasell LDPE
Processing Temperature: | 160-200°C |
---|---|
Melt Index: | 4 G/10 Min |
Shore Hardness (Shore D): | 42D |
Prime Polymer Evolue SP1540 Cast Film Mlldpe
Melt Mass-Flow Rate (MFR): | 3.8 G/10 Min |
---|---|
Density: | 0.913 G/cm³ |
Processing Method: | Cast Film |
Polyethylene LDPE Plastic Pellets Sugarcane Material Green PE Braskem SPB681
Density (23°C): | 0.922 G/cm³ |
---|---|
Melt Mass-Flow Rate (MFR) (190°C/2.16 Kg): | 3.8 G/10 Min |
Molding Temperature: | 170 -190 °C |
Braskem Green PE STS7006 LDPE Pellets Bio Based Polyethylene Granules 0.925 G/Cm3
Density (23°C): | 0.925 G/cm³ |
---|---|
Melt Mass-Flow Rate (MFR) (190°C/2.16 Kg): | 0.6 G/10 Min |
Molding Temperature: | 170 -190 °C |
Lupolen 2420h LyondellBasell LDPE
Elongation At Break: | 800% |
---|---|
Vicat Softening Point: | 100°C |
Tensile Strength At Yield: | 18 MPa |
Prime Polymer Evolue SP2040 Cast Film Mlldpe
Melt Mass-Flow Rate (MFR): | 3.8 G/10 Min |
---|---|
Density: | 0.918 G/cm³ |
Processing Method: | Cast Film |
Prime Polymer Evolue PE SP3530 Cast Film
Melt Mass-Flow Rate (MFR): | 3.2 G/10 Min |
---|---|
Density: | 0.930 G/cm³ |
Processing Method: | Cast Film |
Prime Polymer Evolue PE SP4030 Cast Film
Melt Mass-Flow Rate (MFR): | 3.8 G/10 Min |
---|---|
Density: | 0.938 G/cm³ |
Processing Method: | Cast Film |